Group Buy on Cheap CO2 Regulators

Post Reply
User avatar
Chris Norrick
Brewmaster
Posts: 2544
Joined: Fri Dec 02, 2005 3:21 pm
Location: Evansville, IN
Contact:

Group Buy on Cheap CO2 Regulators

Post by Chris Norrick » Mon Aug 13, 2007 11:27 pm

I'm getting a few of these cheap $5.75 CO2 Regulators and wanted to know if anyone else needs any to split up the shipping. They are called "secondary" regs and handle up to 1000 psi. Although one post on the green board said they were rated to 1800 psi making them suitable for a primary regulator. They are just the regulator body, no pressure gauges or fittings. I'm using them to build a CO2 manifold that can still serve beer and carbonate at higher pressure at the same time!
http://www.sciplus.com/singleItem.cfm?terms=12095

I'm also getting some cheap $5.99 0-60 psi gauges and shut-off check valves from here: LINK

All the nipples, barbs, and end caps from McMaster-Carr.

Check out this post on the green board for this idea taken to the extreme! I'm just getting three and running a T off each one to have 6 total gas outs with three different pressures, if needed. Handy if I ever get a BeerGun. This dude is just nuts.
http://www.brewboard.com/index.php?showtopic=76504

If there is enough interest we could have a regulator building party! Wee! It's a good deal if you consider a 4 gauge one from morebeer is $150! http://morebeer.com/view_product/6914/
Chris Norrick
Up Next: OVHA Barrel Brew
Fermenting:
On Tap:

User avatar
Michael Erwin
Brewmaster
Posts: 577
Joined: Thu May 15, 2008 2:01 pm

Post by Michael Erwin » Thu May 15, 2008 8:32 pm

hi, i'm new to the forum, I realize this is an old post, but...
did you get your system set up and working?
are they rated at 1000psi or 1800?

User avatar
Chris Norrick
Brewmaster
Posts: 2544
Joined: Fri Dec 02, 2005 3:21 pm
Location: Evansville, IN
Contact:

Post by Chris Norrick » Thu May 15, 2008 11:07 pm

Welcome to the Club & Message Board!

Indeed I did. Here are a couple of pics of the setup. I'll have to check on the psi rating. I believe they were stamped 1000 but I'll have to double check. The nipple on the right side feeds down to my primary regulator. I ended up attaching a long hose to one of the outlets and cranking up the pressure to around 30 and I use it to purge kegs before I rack into them. It's very convenient.

[albumimg]263[/albumimg]
[albumimg]264[/albumimg]
[albumimg]245[/albumimg]
Chris Norrick
Up Next: OVHA Barrel Brew
Fermenting:
On Tap:

Post Reply