OVHA Chat
http://ovha.net/phpBB3/

Attenuation Issues
http://ovha.net/phpBB3/viewtopic.php?f=2&t=2722
Page 1 of 1

Author:  jamespotter [ Wed May 16, 2018 12:08 am ]
Post subject:  Attenuation Issues

Hi,

My last two beers have attenuated poorly, about 60%. I've never had this issue before. Assuming my new hydrometer is accurate (with distilled water it read between 1.000 and 1.002), the only thing in common with these two batches is both used maris otter as the base malt (these were the first two batches from a newly opened bag). Both batches were mashed at around 152-154 and fermented within range for the particular yeast strains (WLP001 and WLP028). Could the problem be with the maris otter from this particular maltster? The current beer, a Scottish 80, has been in the concial for just over two weeks, should I try adding back the yeast I saved from the second dump or just leave well enough alone? Thanks for your input?

Please help.

I didn't find the right solution from the Internet.

References:-
http://ovha.net/phpBB3/viewtopic.php?f=2&t=1305
Product demo video production company

Thanks!

Author:  SkyBrew [ Wed May 16, 2018 6:59 am ]
Post subject:  Re: Attenuation Issues

My gut instinct is telling me the brand of grain you are using doesn't matter.

Are you hitting your targeted original gravity? If so the grain would seem to be doing its job.

Usually under attenuation occurs on the fermentation side of the process.

A couple of questions:
1. what strain of yeast are you using?
2. are you pitching enough yeast?
3. what temperature are you fermenting at?
4. are you oxygenating your wort and using yeast nutrient?
5. how long are you fermenting?
6. you said you have a new hydrometer.. have you tried measuring with another device like a refractometer?
7. What temperature are you pitching your yeast at?
8. any off flavors?

Author:  damianwinter [ Wed May 16, 2018 6:30 pm ]
Post subject:  Re: Attenuation Issues

If your basing your attenuation off what on the yeast profile. It's a estimation of attenuation not always true. Fact is that your wort composition is what determines part of your attenuation. To get your max attenuation of your yeast and your wort you will need to do a force ferment test to get accurate results. As sky mentioned some other reasons for for low attenuation. Here is two other things to consider with wort composition. First check to see if your thermometer is accurate. High mash temps creates unfermentible sugars causing a higher final gravity. Second amount of roasted and crystal malts in your recipe these also have a determining factor of your final gravity. Wort composition is very important. I recommend doing a force ferment test of your recipe to find out what your true attenuation is for the yeast..

Page 1 of 1 All times are UTC - 7 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/